After a new generator or a sealed generator has been run-in (the first 50 hours), the following maintenance work is required:
Clean or replace the air filter
Change engine lubricating oil
Replace or clean the filter element of the lubricating oil filter
Retighten the bolts and nuts of each part
The new generator should try to avoid sudden load increase or high-speed operation. Use the lubricant recommended by the manufacturer as much as possible. Do not mix different brands of lubricants. The lubricant contains various additives. The mixture of different brands of lubricants will lubricate. Performance drops, resulting in abnormal wear of moving parts.
When filling fuel into the fuel tank, there should be a filter at the fuel injection port, and it is better to put a filter cloth; the fuel should be left in the fuel tank for more than 24 hours to allow water and impurities to settle before use; usually the drain plug of the daily fuel tank should be opened frequently The head drains the water and sediment at the bottom.
Regular overhaul and planned maintenance are the key to prolonging the service life of the engine. The overhaul period and overhaul items should be adjusted appropriately according to the purpose, use condition, and the properties of fuel and lubricants. If necessary, overhaul should be carried out in advance, as far as possible by professional Technical personnel to complete regular inspections and maintenance.
High-quality imported generator sets are often valuable, reasonable use, attention to daily maintenance, prevention of early wear and tear, prolonging their service life, so that they can always maintain a good ready state of rapid startup and investment, and truly make the best use of the material.
